Ohm’s law for audio

Same voltage, fewer ohms, more amps. Ohms tell you how hard it is for current to flow.

Same 4 volts, two loads

The load is the electrical thing an amplifier is driving. In this teaching example, imagine connecting one simple 8-ohm resistor and then a 4-ohm resistor, sending the same 4 volts to each. These resistors stand in for the speaker's electrical demand; real speakers are more complicated.

Load (ohms)Current (amps)Power (watts)
8 Ω 0.5 A 2 W
4 Ω 1 A 4 W

Why the amp has to work harder

In this test, watts are volts times amps. With the same voltage and twice the current, the 4-ohm load gets twice the power.

The power supply has to keep up, and the circuitry that drives the speaker has to carry the extra current. If the amp reaches its limit, the sound can distort or the amp can shut down to protect itself.

Check what the amp delivers into your speaker’s ohm rating and how low the speaker’s impedance can dip.

Work out the amps and watts Optional

Amps = volts ÷ ohms. For the 8 Ω test load, 4 ÷ 8 = 0.5 A. For the 4 Ω test load, 4 ÷ 4 = 1 A.

Watts = volts × amps for these resistive loads. At 4 V, that is 2 W into 8 Ω and 4 W into 4 Ω.

At a fixed 8 Ω, raising the voltage from 4 to 8 V doubles the current from 0.5 to 1 A. Power rises from 2 to 8 W because both voltage and current doubled.

These examples use RMS voltage and current, a way of describing their effective strength when they change over time. Real speakers do not behave like fixed resistors: their impedance changes with pitch. Voltage and current can also rise and fall at different times (a phase difference), changing the actual power delivered.

Where the voltage goes at a headphone jack Optional

In this example, a jack starts at 1.00 V and has 10 Ω of resistance inside it. Connect a 32 Ω headphone and the same current flows through both parts.

  1. Add the ohms. 10 + 32 = 42 Ω.
  2. Divide volts by total ohms. 1.00 ÷ 42 ≈ 0.0238 A.
  3. Multiply that current by each part’s resistance. About 0.24 V drops inside the jack and 0.76 V reaches the headphones.
0.24 V across the jack’s resistance0.76 V across the headphones

With fewer headphone ohms, more current flows and the jack drops more voltage. See what happens on two different notes.